AI Signal Pool Generator
Use AI to automatically generate matching signal pool configurations based on your prompt strategy.
Prerequisites
It's recommended to first create a prompt strategy using the AI Prompt Writer, then send the prompt to the signal system AI as a reference.
Open AI Signal Settings
Go to the Signals interface and click the AI Signal Settings button in the top right corner.
.png)
AI Guided Q&A
After sending your prompt, AI will ask about your requirements:
- Trading Direction: Long only, short only, or both directions
- Signal Type Preferences: OI (Open Interest), CVD (Cumulative Volume Delta), Funding Rate, Depth Ratio, Taker Volume, etc.
- Trigger Frequency: How often you want signals to trigger
.png)
AI Backtesting and Adjustment
After you send these requirements to AI, it will start backtesting and adjusting the signal values in the signal pool to meet your needs.
If you clearly know which signals your strategy needs, you can tell AI directly. If you also know the exact values, you can manually create signals and signal pools.
.png)
Create Signal Pool
After backtesting completes, AI will output an introduction to the signal pool. If you find anything unreasonable, you can point it out and ask AI to modify it.
When satisfied, click Create Signal Pool.
.png)
Signal Combination Logic
Signal pools support two combination logics: AND (all conditions must be met) and OR (any condition triggers). AND logic is stricter with lower trigger frequency; OR logic is more lenient with higher trigger frequency.
Signal Backtest Verification
After successful creation, close the AI Signal Generator, then click Signal Backtest to verify if it's reasonable.
.png)
On the signal backtest page, you can also click Check Market to view the market state at each trigger time.
.png)
Market Regime Adjustment
For example, when this signal pool triggered, the market was in a continuation state.
.png)
Market regime values can also be adjusted based on your experience or preferences.
.png)
Bind to AI Trader
Finally, don't forget to go to the AI Trader interface to select the signal pool you need and save.
.png)
Next Steps
After completing signal pool configuration, continue learning:
- Dashboard & Monitoring - Monitor trading performance
- FAQ - Common problem solving